How to smoke a good cigar

How to smoke a good cigar Lighting the cigar correctly is an essential part of the process, not only from the point of view to ensure that it bus smoothly and evenly, but the ritual is part of the pleasure of smoking a cigar. Cigars by hand must be cut before lighting. Using a knife, scissors or ideally a cigar cutter, remove the cigar off, leaving about an eighth of an inch (3mm) of the CAP remains. Make quick and clean cut to avoid damaging the leaves. The real trick is to be decisive, once you've aligned the cut, make a snap movement, a shy, anxious to rip-cut sheets. In light cigar, hold the cigar and width to meet the flames until the end (remember to use a slight odor, not a gas station light) by tuing the cigar so that the end is evenly charred, blowing on the charred order to create a slight glow, which helps the good cigar that bus. Now slowly pull the cigar, holding it near the flame, but not quite, touch the cigar. Slowly rotate the cigar in the flame to bu. Blowing gently lighted at the end even regularity. Once the cigar is lit, lets you smoke waft around your mouth, enjoy the flavor. Do not breathe too much and cause overheating and breathing, like a cigarette. A good cigar will create an ash that you can get an inch (2.4 centimeters). Do not browse this too often, unlike a cigarette, cigar or the risk of buing or unevenly. If the cigar out, you press any buing ash from the end and start the process of lighting from the start. When the cigar is about an inch (2.5 cm) from the middle of the band, it's time to quit. Place the cigar in an ashtray and soon extinguished. Remember to dispose of the butt, as soon as possible. The old adage that "The only time a like a good Havana cigar in the ashtray. "